Innovative BV100, Operation Manual

Page: 8 / 47

Copyright Innovative Technology Ltd 2008 GA717
4 MACHINE INTERFACES
4.1 BEZEL LEDs
The Bezel LED’s are used to indicate a variety of status signals as described below.
LED Status Description
Permanent On Validator enabled ready to accept notes
Slow flash on power up
(1 second period)
Power supply is incorrect, check specification
Slow flash
(1 second period)
Validator in Configuration Card Mode
Short flash Cash box removed
Table 5 – Bezel LED status codes
4.2 HARDWARE
4.2.1 PORTS AND BUTTONS
The BV100 interface connector is located on the left side of the unit; it has 16 pins (see
Figure 2), refer to Table 6 for the pin allocation. Two are used for the 0V and +12V power
supply and there are five outputs and five inputs, the remaining four pins are reserved for
factory use and should not be connected. An example mating connector is Molex type Part
No: 39-51-2160.
It is possible to use the special hardware versions of BV100 in machines operating at 110
volts or in machines operating at MDB.
The BV100 also has a Configuration Button located above the USB Connector (See Figure 2).
The USB connector can be used to program the BV100 and for communications when used
in SSP and SIO modes. When used for programming, no external power supply is required.
When used for the communications, power must be applied to the BV100 via the 16 pin
interface connector before connecting the USB cable.
BV100 Operations Manual 8