Innovative BV100, Operation Manual

Page: 28 / 47

Copyright Innovative Technology GA717
9.4 APPENDIX D – CONFIGURATION CARDS
The following pages contain the information corresponding to the document number
GA713. To print the cards, ensure that the page scaling is set to ‘none’. Always ensure
that the card has printed with the correct dimensions before use.
BV CONFIGURATION OPTION PROGRAMMING
Instructions for use
1) Select correct width card for bezel. Cut card around outline – check measurements
as printed. Check print options ‘Page scaling’ is set to ‘none’ when printing a pdf file to
ensure correct size.
2) Fill in sections as required. Take care to fill in the selections correctly, keep inside
the lines and fill boxes fully as example below.
3) Power up BV100 and allow it to reset.
4) Click ‘function’ button on BV to access Configuration Mode, BV bezel LEDs should be
flashing at 1 second intervals.
5) Enter card into BV in direction indicated by arrows.
6) Card will be returned and if configuration was good the bezel LEDs will flash rapidly
while programming takes place. take care to ensure the power is not removed at this
stage, the bv may suffer permanent damage!! The BV will then reset.
7) If an error occurs has occurred the card will be rejected and the bezel LEDs will flash
slowly a number of times to indicate the cause of the error. (see table below)
8) important check that the configuration requested has been set in the BV100 before
use .
Flash Error
2 Invalid card read – card entered wrong way round, card mis-read or card
wrong version
3 No interface selection was detected on card
4 Multiple interface selections detected
5 Invalid interface selected – the selected interface is not available for
this BV
6 Selected interface not compatable with BV version
7 Pulse configutration error. Selected pulse options invalid.
8 ccTalk configuratrion error. Selected cctalk options invalid (ccTalk 8 bit
chk not allowed without ccTalk Plain)
9 Low power mode not available on this BV version
NV200 Operations Manual 31
BV100 Operations Manual 28