DELUXE
Inverter
Service
M
anual
(the cooling only A/C only runs under fan mode),
t
he internal fan runs for three minutes with
weak wind before stop. The purpose of this function is to dry the inside of the evaporator and to
prevent the evaporator from going moldy due to water deposition and thus dispersing strange smell.
Note:
1. This function has not been set in the factory. You may freely set and cancel this function. The
setting method is: under “off” status of the A/C and the remote controller point the remote
controller toward the A
/
C and continuously press “Anti-FUNGUS” pushbutton for one time
the buzzer keep
s
beeping five times again after five times beep
s
indicating that this function is
ready. In case this function has been set, unless the whole A
/
C is powered off or the function is
manually cancelled, the A
/
C
will have
this function as default;
2. To cancel the function: 1.Power off the whole A/C; 2. Under “off” status of the A/C and the
remote controller point the remote controller toward the A/C, and continuously press “Anti-
FUNGUS” pushbutton for one time , the buzzer keep
s
beeping three times again after five
times
beep
s
indicating that this function has been cancelled;
3.
If
this function is on, it is suggested not to restart the A/C before it
ha
s completely sto
p
p
ed
;
4. This function will not run in case of time stop or sleep stop.
15.
“
iFavor
”
button
The button is a shortcut, users could reserve the data of mode, wind speed, set temperature, swing
and when pressing on it, it could operate in the mode users set before. Method:
1.turn on the air
conditioner make adjustment to the ideal mode you wanted.
2.keep pressing the shortcut button for
three seconds till the display screen give
s
the signal that represents the shortcut button and gl
ows
for
three times then reserve the operation mode in the remote controller it's done. To take place of the
previous operation mode just do it as shown above
.
16.
button
The temperature is displayed by default in Celsius. To set the temperature display to Fahrenheit, Press
'' " and “MODE" buttons at the same time for at least 3 seconds whether the remote controller is on
or off .
Press
“△”
and "MODE" buttons at the same time again for at least 3 seconds to restore the
temperature display to Celsius.
Note: Temperature display in Fahrenheit is not available for some models. When temperature
is displayed in Fahrenheit on the remote controller, it might be in Celsius on the unit, the
function and operation of which will not be affected.
These combined buttons are for remote controllers with
℃
/
℉
switching function only if there
is no "
" symbol on your remote controller, then switching function is not available.
7
