29
700-398-01J X-Series User Manual Issued for version 2.8x
16.
The keypad displays “…Confirming…”.
17.
Release the remote button
18.
The keypad displays “Success”, “Rt User R M B”.
19.
Press the [*] key to return to steps 9-18 if you wish to add more remotes.
20.
Once you have finished, press the [#] key to exit programming.
NOTE: If you were unsuccessful, the keypad will display “fail”. If the procedure did fail, the menu will retain the
setup information and will retry training upon a [*] entry.
LED Keypad
1.
Hold the [*] key until the beep (3-4 seconds).
2.
The READY and ARM LEDs flash alternately.
3.
Enter [MASTER CODE] followed by the [*] key.
4.
The READY LED flashes.
5.
Enter [2] [1] followed by the [*] key.
6.
The READY and ARM LEDs flash simultaneously.
7.
Enter [RECEIVER NUMBER], which could be 1, 2, 3, or 4, followed by the [*] key.
8.
The READY and AWAY LEDs flash simultaneously, and the ARM LED is on.
NOTE: Remote Receiver 1 is indicated by zone LED 1 coming on, Remote Receiver 2 is indicated by zone LED 2
coming on’ Remote Receiver 3 in indicated by zone LEDs 1 +2 coming on, Remote Receiver 4 is indicated by
zone LED 3 coming on.
9.
Enter [USER CODE] followed by the [*] key.
10.
The READY and POWER LEDs flash simultaneously, and the ARM and AWAY LEDs are on.
11.
Enter [MANAGEMENT BUTTON], which could be 0, 1, 2, 3, 4, followed by the [*] key.
12.
The READY LED flashes and the ARM, AWAY, and POWER LEDs are on.
NOTE: Button 1 is indicated by zone LED 9 coming on, Button 2 is indicated by zone LED 10 coming on, Button 3
is indicated by zone LEDS 9+10 coming on, Button 4 is indicated by zone LED 11 coming on.
13.
Press the [*] key to proceed, or the [#] key to abort.
14.
Press and hold the remote button.
15.
The ARM and AWAY LEDs flash simultaneously, and the READY and POWER LEDs flash simultaneously.
16.
Release the remote button.
17.
The ARM and AWAY LEDs flash simultaneously, and the READY and POWER LEDs flash simultaneously.
18.
Press the [*] key to return to steps 9-17 if you wish to add more remotes.
19.
Once you have finished, press the [#] key to exit programming.
NOTE:
If you were unsuccessful, the READY and ARM LEDs flash simultaneously, and the AWAY and POWER
LEDs will flash simultaneously. The keypad also beeps 3 times, twice. If the procedure did fail, the menu
will retain the setup information and will retry training upon a press of the [*] key.
If the management buttons on a Remote Transmitter have been assigned to various user codes and it is
desired that the remote be reverted to a single-user transmitter (i.e. button 1 is arm/disarm, button 3
is stay arm etc.) then all user codes on that Remote Transmitter have to be deleted before
reprogramming. If the users are not deleted then the Remote Transmitter will continue to operate in
management button mode.
