15
700-398-01J X-Series User Manual Issued for version 2.8x
6.
Enter the [ZONE NUMBER] followed by the [*] key. Alternatively you can use the [PANIC] or [MED]
keys to scroll through the zones. (Y next to the zone number indicates that it has been bypassed and
N not bypassed)
7.
Press the [*] key to toggle between zones being on and off.
8.
Repeat steps 6-8 to bypass/un-bypass other zones.
9.
Press the [#] key to exit the bypass mode.
NOTE: Panic zone can only be bypassed if enabled by the installer and to bypass select zone 65.
Fire Alarms
Hold down the [F] key until the beep
If the [F] key is pressed until the keypad beeps (1 second) a FIRE ALARM condition will be activated.
The POWER LED stays on and the ARM LED flashes.
The FIRE ALARM condition may also be triggered by a smoke detector connected to an appropriately
programmed zone.
The siren will sound on and off repeatedly if programmed and the FIRE REPORTING CODE will be
transmitted to the monitoring company.
To silence the siren enter a valid [USER CODE].
Panic
Hold down the [P] key until the beep
If the [P] key is pressed until the keypad beeps (1 second) a PANIC ALARM condition will be activated.
The POWER LED stays on and the ARM LED flashes.
A PANIC ALARM may also be activated using any FIXED PANIC button or a REMOTE PANIC button (if
installed).
If the audible panic option has been selected, the siren will sound. A PANIC ALARM will be transmitted
to the monitoring company.
To silence the siren, enter a valid [USER CODE].
Press the [P] key only in an emergency situation that requires response by emergency personnel.
Medical Alarms
Hold down the [M] key until the beep
If the [M] key is pressed until the keypad beeps (1 second) a MEDICAL ALARM condition will be
activated.
The keypad buzzer will beep 5 times.
A medical reporting code will be reported to the monitoring company.
Duress Alarms
[#] [DURESS CODE]
This is a special user code that should only be used in the unique situation where an intruder forces one
to disarm the system “under duress”.
When a [DURESS CODE] is entered, the control panel disarms.
A Duress Alarm Code (if programmed) will be reported to the monitoring company.
It is advisable to choose a Duress code that can be easily remembered by all.
