HandPunch 3000/4000 Manual
43
Erasing the Memory
There are two options when erasing the memory of the HandReader:
1.
Setup
2.
All
The erasing of the setup will set the HandReader’s address, passwords, etc.,
back to factory defaults.
Choosing the All option will take the HandReader’s setup back to factory
defaults plus erase all user databases and datalogs. This action cannot be
undone. If there is a software that is managing the system then the users can
be downloaded back to the HandReader if needed.
The erase memory function allows a HandReader’s setup and/or user
database to be erased.
Perform the following steps to erase the setup programs but retain the user
database.
1.
With system power OFF, depress reset switch.
2.
Turn system power ON and wait 5 seconds.
3.
LCD screen will display.
Erasing
HandReader
Memory
ERASE
:1 SETUP
:9 ALL!!!
Summary of Contents for SCHLAGE HP-3000
