HandPunch 3000/4000 Manual
93
Perform the following steps to erase the configuration data but retain the
user database.
1. With system power OFF, set switch 4 ON.
2. Turn system power ON and wait for HandPunch boot information to
appear on the display.
3. Turn switch 4 OFF.
Perform the following steps to erase both the configuration data and the user
database.
1. With system power OFF, set both switches 4 and 5 ON.
2. Turn system power ON and wait 5 seconds.
3. Turn both switches 4 and 5 OFF.
Before putting the HandPunch into service ensure DIP switches 4 and 5 are
both OFF. If switches 4 and 5 are not off, the next time the HandPunch’s
power is cycled the HandPunch’s memory will be erased.
Erasing the
HandPunch
Setup
Erasing the
HandPunch
Setup and
User Database
NOTE
Summary of Contents for SCHLAGE HP-3000
