Ingersoll-Rand SCHLAGE HP-3000, User Manual

Page: 25 / 101

HandPunch 3000/4000 Manual
23
Mechanical Installation
Select an installation location based on the guidelines provided in the Planning
an Installation section beginning on page 11.
For the following instructions protect the HandPunch from the dust and debris
generated during the wall plate installation process.
1.
Remove the wall plate from the packing carton. Refer to Figure 3-1 for all
wall plate references in the following section.
Wall Plate
Installation
2 UPPER SCREWS
3 LOWER SCREWS
LEVELING HOLE
SURFACE
CONDUIT
ENTRY
Figure 3-1: Wall Plate
2.
Measure and mark a point 42 1/2 inches (123 cm) from the surface of the
finished floor. This point will correspond to where the top-center point of the
HandPunch should be mounted.
3.
For a hollow wall, drive a small nail into the wll at the mark and hang the
wall plate from the leveling hole located near the top of the wall plate.
4.
For a solid wall, hold teh wall plate against the wall, centering the leveling
hole over the mark in the wall.
NOTE