Programming the HandPunch
58
Table 9: Setup Command Menu
Setup Menu
Password = 2
Set Serial
a
Verify/Enter IP Address
Verify/Enter Gateway
Verify/Enter Host Bit
Set Output Mode
For Lock & Auxiliary (Y/N)
For Card Reader Output (Y/N)
Upgrade
Code
a.
The Set Serial command has different
values based on whether the HandPunch
unit is configured for serial or modem
communication versus Ethernet
communication.
The Set Language command allows the language shown on the HandPunch’s
display to be “localized” for a variety of countries:
-
English
- German
-
Japanese
- Russian
-
French
- Indonesian
-
Italian
- Portuguese
-
Spanish
- Polish
The Set Date Format Command allows the date format shown on the
HandPunch’s display to be “localized” for a variety of countries.
-
mm/dd/yy
- mm-dd-yy
-
dd-MMM-yy
- MMM dd,yy
-
dd-mm-yy
- ddMMMyyyy
-
dd/mm/yy
The Set Time and Date command allows the HandPunch’s time and date to be
set. This is normally not necessary as the HandPunch’s time and date are set
by the host computer.
Set Language
Set Date
Format
Set Time
and Date
Summary of Contents for SCHLAGE HP-3000
