EonStor / EonStor DS S12/S16/S24 Series
135
Power On Status Check
LED(s) that light up
red
/
amber
nor should you hear an audible alarm from the
system. You should begin verifying system statuses via the following monitoring
LEDs on LCD keypad panel
:
The LED on the LCD keypad panel should
illuminate after a successful initialization process, indicating that system
status is ready. System initialization and the power-on self-test may take
up to five minutes and the system fault LED may light up duri g the
process. The system fault LED will turn off after a successful boot-up
ocess (refer to
Front Panel Components
As a general rule, once the system has been powered on, there should
NOT
be
interfaces:
n
pr
).
LEDs on rear chassis, including controller module, PSUs, and cooling
modules (refer to
System Monitoring
1
2
3
4
5
6
1 2 3 4 5 6
Ctr
l St
atu
s
CB
M S
tatu
s
1 2 3 4 5 6
).
ATTN LED: OFF
Controller LEDs:
Status
LED:
On
(
green
)
C_Dirty LED: Off
Temp LED: Off
CBM Status LED: On
(
green
) or Off
LCD Panel LEDs:
PWR LED: OFF
117
