Use
r’s
Manual of OMNI Express Patient Monitor
89
037.007.0001 Rev.2
GRID OUTPUT
For printer paper without a grid, you can set the grid form in order to observe the
waveform easily. You can set the grid by following the instructions in the Chapter SYSTEM
SETUP.
When Grid Output is set to ON (default setting is OFF), then the parameters will be printed
in the grid format.
PRINT ALARM EVENT
When a parameter value violates the range limits, you can recheck the alarm trend by
pressing the
“Trend” soft-key and choosing “Alarm Event”. In the Alarm trend menu, you
can choose the
“Print” item to record the alarm information.
The printout for an alarm report includes Patient Name, Alarm Message, Alarm Happened
Time, waveform if the parameter has one and the data associated with the parameter.
Figure 38: Alarm Event Print
If the alarm print setting is turned ON, it will print the waveform over a period of 8 seconds
(the 4 seconds before and after the alarm) when the alarm is triggered.
PRINT EVENT LIST
Print out the event list for review.
Figure 39: Event List Print
PRINT EXPLANTION
INSERTING PAPER
Press the button on the catch of the printer, open the catch, take the old paper roll out and
insert a new one into the paper cassette. Make sure that the paper can spin freely. Pull a
small length of paper out of the catch from the lower end of the roll (If it is the upper end,
then paper reel was installed conversely), close the catch, and make sure that the paper is
just in the groove. Otherwise, the paper advance will not be print properly.
ATTENTION
◼
The printer cannot print continuously for more than 2 minutes.
◼
DO NOT press the print button if there is no paper because the printer head will
be damaged.
◼
Only thermal printer paper can be used.
◼
If there is too much dust, use a sponge lightly moistened with alcohol to clean the
parts of the printer.
[NOTE]:
“-------”
means invalid parameter.
