Use
r’s
Manual of OMNI Express Patient Monitor
88
037.007.0001 Rev.2
PRINTER (OPTIONAL)
◼
PRINTER SETUP
◼
PRINT REAL-TIME WAVEFORM
◼
PRINT TABULAR TREND
◼
GRID OUTPUT
◼
PRINT ALARM EVENT
◼
PRINT EVENT LIST
◼
PRINT EXPLATION
◼
WAVEFORM PRINT EXPLARION
PRINTER SETUP
Please refer to chapter SYSTEM SETUP for details.
PRINT REAL-TIME WAVEFORM
Press the
“Print” soft-key. The statement “Printing Started” should appear on the bottom of
the screen, indicating that the print process has begun. If you want to terminate the print
job during the printing process, just press the
“Print” soft-key again. The printer will stop
immediately and the statement
“Printing Stopped” will appear on the bottom of screen.
The monitor can print a burst of two or three waveforms and the waveforms data from the
previous 8 seconds will be printed.
The print contents also include Patient Name, Hospital name, Print Time, HR, ST, RESP,
SpO
2
, NIBP (SYS, DIA,) Temp, EtCO
2
, Gas and so on. See graph below:
Figure 36: Real-time Waveform Print
PRINT TABULAR TREND
Not only can you print the basic parameter trend table, but also other special table such as
EtCO
2
Tabular.
Figure 37: Basic Tabular Trend Print
[NOTE]:
Printing a table is enabled when the relevant module is opened.
[NOTE]
: The monitor uses a thermal printer, which must use thermal printer paper (the
specification is 48 mm on width).
