Use
r’s
Manual of OMNI Express Patient Monitor
- 13
037.007.0001 Rev.2
OPTIONAL MODULE
You can input different passwords to open the relevant modules such as QTemp, EtCO
2
and Gas.
WAVEFORM SELECT
Select
WAVEFORM SETUP
item to pop up the menu of system Setup.
The waveforms from top to bottom can be selected from ECG I, ECG II, ECG III, ECG
avR, ECG avL, ECG avF, ECG V, Pleth, Resp, EtCO
2
and AG.
The EtCO
2
and AG can be chosen only when the related module is opened.
PRINTER
Select the
PRINTER
item in the SYSTEM SETUP menu to finish the settings below.
STATUS
Use to display the connecting state of printer. Connected or Disconnected.
GRID OUTPUT
Set to ON to make waveform print out have a net background, just like record paper.
ALARM PRINT
If this item is set to ON, the monitor will print a 8 second slip of waveform (the preceding 4
seconds before the recording till the current 4 seconds) when an alarm is triggered.
AUTO PRINT
Available intervals are every 5 minutes, 10 minutes, 20 minutes, 30 minutes and 60
minutes, if the
“Parameters Only” menu item is selected, then after related interval, the
monitor will automatically print only Parameters
’ values. If it is set to off, it will print
Waveform and Parameters
’ values automatically. By turning auto print “OFF”, printing will
only occur when manually executed.
PARAMETERS ONLY
If this item is set to ON, the monitor will print only the Parameters
’ values. For example, it
will only print the values of HR, NIBP, SpO
2
, ST, Temp, EtCO
2
, Gas and so on.
WAVEFORM 1 or 2 or 3
This item is to choose what waveform is to be printed out.
HOSPITAL NAME
Click this item to input or change the hospital name. When clicking the input name
location, a keypad will display, and you can select any letter on it as in the following
illustration:
