6 | Operation
INFICON
38 / 90
HLD6000-Operating-instructions-kinb43en1-05-(2107)
1
> Setup > Request
2
Select "off" or input a time interval.
3
Confirm with
.
6.2.7 Setting the filter change request
See also “Replacing the filter holder (all sniffer lines) [
1
> Setup > Request
2
Choose "on" or "off".
3
If you have chosen the setting "On", you can set the timespan between two
requests.
4
Confirm with
.
6.2.8 I/O module
Introduction information: Instruction manual IO1000 I/O module, document no. jiqc10
6.2.8.1 Create a connection between the device and the I/O module
1
Switch the instrument off.
2
Connect the INFICON I/O module with a data cable to the M12 socket on the
rear of the device, see "Basic unit [
13]", Fig. 2.
3
Switch on the HLD6000.
4
> Setup > Interfaces > Device selection
5
Select "I/O".
6
Confirm with
.
6.2.8.2 Configuring analog outputs
You can determine how the voltage of the analog outputs is set.
1
> Setup > Interfaces > I/O module > Analog outputs
2
For "Config. analog output 1" or "Config. analog output 2" choose between:
– Set by interface
– Leakage rate linear
– Off
3
Confirm with
.
Summary of Contents for HLD6000
