Figure 4: The ProMove-mini node and the reference X, Y and Z-axis
•
Double blink
: Transmitting data via USB or wireless. Synchronized nodes should blink at
the same time.
•
Five blinks
: Logging to flash memory.
The button has the following functionality:
•
Pressing short once
: Turns the node on; it is also used to confirm pairing via Bluetooth.
•
Pressing short twice
: Starts or stops logging to the flash memory.
•
Pressing long once
: Turns the node off. Pressing more than 5 seconds will powercycle
the node.
3.4
Attachments
Velcro straps can be attached through the handles, as shown in Figure 5.
3.5
Recharging the batteries
The internal battery of the ProMove-mini should be periodically recharged. This can be done
by using a cable connecting the micro-USB connector of the node to a computer or a standard
USB charger . A fully drained battery takes approximately 2 hours to recharge. During charging,
the green LED of the node is on. The gateway has no internal battery and therefore does
not require recharging. Monitoring the battery voltage can be done using Inertia Studio (see
Page 8 of 60
