4.8.8
IMA settings
ProMove-mini is able to calculate IMA (Integral of the Modulus of the Accelerometer) mea-
surements. Figure 30 shows the IMA Settings, with the following parameters:
•
Enabled
: Enables calculating IMA measurements (note that the Accelerometer should also
be enabled).
•
Transmit Data & Log to Flash
: If IMA measurements are enabled, data is transmitted and
logged to flash when required (see Section 4.8.1 for global transmission settings and Sec-
tion 4.4.1 to start a flash log).
•
Sampling Rate (Hz)
: The sampling rate at which data for the IMA measurements is collected
(maximum 1000 Hz).
•
IMA Interval (s)
: The time in seconds at which an IMA measurement is calculated.
•
Values per Message
: The number of IMA measurements to send at once.
Figure 30: IMA Settings
Page 38 of 60
