4.8
Configuring the sensors
The
Sensor Settings
window can be used to modify the configuration of Inertia nodes. This
window is accessible via the toolbar and via the
Configuration
menu, item
Sensor Settings...
.
Once a device is connected, the configuration options of the detected Inertia nodes is shown
in this window.
Figure 22: Sensor Settings
Figure 22 shows the
Sensor Settings
window, which is divided in the following areas:
•
The node list area
, marked with
green
in Figure 22, contains the list of devices available
via the currently selected connection. When a node is
selected
, its configuration options
are shown in the sensor tree. When a node is
checked
by using the checkbox beside it,
the actions of the buttons refer to this node. In Figure 22, all nodes are checked, so the
configuration is applied to all these nodes after pressing the
Apply Settings
button.
•
The sensor tree
, marked with
red
in Figure 22, shows the available configuration op-
tions of the selected nodes in the node list. When choosing an option in the tree, the
corresponding configuration settings are shown in the settings panel. The different con-
figuration options in the sensor tree are discussed in the subsequent sections.
Page 29 of 60
