21
21
Timer Stage2 Tab
Stage2 Timer, Timing Retard Control
‐
this se ng con
fi
gures the Stage2 Timer, +12V output to be On whenever Stage2 Nitrous
is On (Solenoids func oning). Check to enable.
If this se ng is O
ff
then the Timer2 output can be con
fi
gured by selec ng which control parameters are used to turn On the output.
When more than one control parameter has been selected all must meet the condi ons as con
fi
gured before the output will func on.
Example
‐
Ac va on Input Enabled and RPM Enabled, RPM On = 2000 and RPM O
ff
= 4000, the Timer2 output will only be on when the
Ac va on Input is ac ve and the engine rpm is between 2000 and 4000 rpm.
This output su12V when On.
This output may be used to drive an external relay with a load of no more than 1 amp. The relay can then be used to control another
stage of nitrous with no progressive ramp.
Note—the “Timing Retard Control” must be un
‐
checked (o
ff
) for these features to
be enabled.
Timer Stage1 Con
fi
gura on
‐
check to enable which control parameters are used to deter
‐
mine when the Stage1 Timer +12V output will be On. This output su12V when On.
Any op ons that are selected are combined to determine if the output should be on or o
ff
.
Delay Timer
‐
these se ngs control the Delay me and On me
for the Timer output.
Valid range
‐
0.000 to 10.000 in .001 Second increments.
Engine RPM
‐
these se ngs control the output based on Engine
RPM.
Valid range
‐
0 to 16000 in 10 RPM increments.
Stage2 Nitrous Percent
‐
these se ngs control the output
based on Stage2 Nitrous Percent.
Valid range
‐
0.0 to 100.0 in .1 Percent increments.
Stage2 Fuel Percent
‐
these se ngs control the output based on
Stage2 Fuel Percent.
Valid range
‐
0.0 to 100.0 in .1 Percent increments.
Stage1 Nitrous Percent
‐
these se ngs control the
output based on Stage1
Nitrous Percent.
Valid range
‐
0.0 to 100.0
in .1 Percent increments.
Stage1 Fuel Percent
‐
these
se ngs control the output
based on Stage1 Fuel Per
‐
cent.
Valid range
‐
0.0 to 100.0
in .1 Percent increments.
