24
24
Data Tab – Data Setup
Data Log Ac va on
‐
these se ngs determine when the controller begins recording data.
If more than one op on is selected ALL condi ons must be met before a new data log will
start.
Example
‐
Ac va on input and Clutch/Trans Brake input both selected, a new data log will
begin recording when both inputs are ac ve. This would be a typical setup when making a
pass at the track. Once staged the Clutch/Trans Brake would be on, then when the wide
open thro le switch goes ac ve the controller would begin a new data log..
Example if on a chassis dyno and the Clutch/Trans Brake input is not being used you would
want to have only Ac va on input selected to start a new data log..
RPM
‐
this se ng determines the Engine RPM when the controller begins recording data.
Valid range
‐
1,000 to 10,000 in 10 RPM increments.
Data Tab – Data Chart
Data Log Navaiga on and keyboard shortcut keys.
Right and Le arrow keys
‐
pan cursor right and le , use SHIFT + Right/Le and CTRL + Right/Le keys to pan by small increments.
I
‐
Zoom in, O
‐
Zoom out.
Le click on chart tle at top of window to turn chart ON/OFF in the graph.
Right click on chart tle at top of window to set chart op ons.
Le click on current chart tle (top right side of graph) to select next chart.
Right click on graph to set run start and end me.
To change the grouping of chart tles, hover mouse over top of graph and when the cursor changes, le click and drag graph height up
or down as desired.
The graph se ngs will be saved when the program is closed and reloaded when the program is launched.
Click tle to turn on/o
ff
Drag chart height here to adjust tle display
