27
27
12 Volt Timer Output Wiring
12 Volt Timer Output Wiring
Relay Ground Output Wiring
This output pr12 volt at 1 amp maximum, there is an internal 1k ohm resistor to ground so the output is not
fl
oa ng when in
the o
ff
state. If your igni on and/or igni on ming controller is ac vated by a +12 volt signal the 20ga
Blue
Stage1 Output wire can be
connected directly to retard ac va on.
Important—always test for proper ming retard opera on before spraying nitrous! You can use a ming light or a data logger if it is
equipped to log igni on ming. Do a dry test (engine running, solenoids unplugged) to con
fi
rm proper ming retard.
This output pr12 volt at 1 amp maximum, there is an internal 1k ohm resistor to ground so the output is not
fl
oa ng when in
the o
ff
state. If your igni on and/or igni on ming controller is ac vated by a +12 volt signal the 20ga
Purple
Stage2 Output wire can
be connected directly to retard ac va on.
Important—always test for proper ming retard opera on before spraying nitrous! You can use a ming light or a data logger if it is
equipped to log igni on ming. Do a dry test (engine running, solenoids unplugged) to con
fi
rm proper ming retard.
This output provides a ground with a 1 amp
maximum load.
If you are driving an LED shi light and it draws
less than 1 amp of current it can be connected
directly to the Brown wire with no relay needed.
If the load is over 1 amp a relay must be used.
To control a load greater than 1 amp a relay will need
to be wired into the system as outlined to the right.
To control a load greater than 1 amp a relay will need
to be wired into the system as outlined to the right.
