Inax Regio DV-R115-VL-US, User Manual

Page: 72 / 83

T
roubleshooting
71
Before Requesting Professional Repairs
In many cases, problems can be easily corrected. Please check the following items before placing a service call.
If a problem cannot be corrected after checking the items below, please contact your dealer for service.
All Functions
Symptom Cause Solution
No functions operate.
(The POWER LED is not
illuminated.)
Current is not supplied to the outlet.
Check for a power failure or tripped
breaker, etc.
The POWER button is off (POWER
LED).
Press the POWER button and light
the POWER lamp on the toilet body
indicator.
☞
See page 2.
The power cord is not connected to the
outlet.
Fully insert the power plug into the
power outlet. Wait for about 10
seconds before inserting the power
plug again.
☞
See page 15.
The remote control unit does
not operate. (The POWER
LED is illuminated.)
The batteries are dead (low battery
indicator flashes).
Replace the battery with a new one.
☞
See page 66.
The batteries are not inserted
correctly.
Insert the battery in the correct
direction.
☞
See page 66.
The remote control’s transmitter/
receiver is dirty or wet.
Remove dirt or water.
An fluorescent light with inverter
ballast is used. Turn off the light and check the
operation.
The remote control unit is turned off.
Press the POWER button on the
remote control.
Seat Heating
Symptom Cause Solution
The toilet seat is not warm.
The seat temperature is set too low.
Press the SEAT TEMP. button to
adjust the temperature to a higher
setting.
The power save function is activated.
Cancel the power save function.
☞
See page 28.
The toilet seat temperature
drops when seated for long
periods.
The toilet seat heater auto off function
is operating.
Cancel the toilet seat temperature auto
off function.
☞
See page 41.
Trouble Shooting