Impediment RS-0800-LVD, User Manual

Page: 7 / 58

Preface
vii
Preface
What is in this guide
This user guide gives you step-by-step instructions on how to install, configure and connect the RS-0800-
LVD storage subsystem to your host computer system, and how to use and maintain the system.
Who should use this guide
This user guide assumes that you have a working knowledge of the Ultra-320 Small Computer Systems
Interface (Ultra-320 SCSI) environment into which you are installing the RS-0800-LVD system. If you do
not have these skills, or are not confident with the instructions in this guide, do not proceed with the
installation.
International Standards
The RS-0800-LVD storage system complies with the requirements of the following agencies and
standards:
• CE to IEC 950/EN60951
• UL 60950
• cUL
Potential for Radio Frequency
Interference
USA Federal Communications Commission (FCC)
Note This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission
limits. The supplier is not responsible for any radio or television interference caused by using other than
recommended cables and connectors or by unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.