Selenio™ Network Processor
User Guide
Configuring Processors
© 2019 Imagine Communications Corp.
Proprietary and Confidential.
May 2019 | Page 87
Configuring a Remap Personality
The Remap personality remaps UHD between SQD and ST 2110 or 2SI signal formats.
In Remap Mode each Processor Section has one Program. Each program has a configuration page. SQD
is only available on the SDI input or output.
Remap 2SI to SQD
Ensure that the IP WAN has been configured before setting up any receivers, and that your SNP is
configured for Remap personality.
To configure a SNP program as receiving 2SI video from IP input, and transmitting it out as SQD over SDI
(which is the only way SNP can output SQD), follow these steps:
1.
Choose the
Section Input mode
as
IP
for the section of the processor you're working on.
2.
Click the Program you want to configure to open its Configuration dialog box.
3.
On the
Input
tab, make WAN-related configurations as appropriate for your network, including the
following:
▪
Check the "Video IP Receiver Enable" checkbox.
▪
Set the correct Receiver Video Standard.
▪
Set the Primary and Secondary WAN selects.
▪
Set the Primary IP address, UDP port, and (optional) multicast source.
▪
Set the for secondary IP address, UDP port, and (optional) multicast source.
If the IP address is set to 0.0.0.0 and UDP port is set to zero, no input will be expected on this
interface.
4.
On the
Video
tab, remove the check beside
Enable Force Video Standard
.
5.
On the
Output
tab under
Pixel Format
, select
Square Division
.
Note:
Choosing SQD as the pixel format will disable IP output.
6.
Click
Apply
to save your changes.
Your SNP is now ready to convert IP video to output SQD.
Remap SQD to 2SI
Ensure the IP WAN has been configured before setting up IP transmitters, and that your SNP is
configured for Remap personality.
To configure a SNP program as receiving SQD video from SDI input (which is the only place SNP can get it
from), and transmitting it out as 2SI over IP, follow these steps:
1.
Choose the
Section Input mode
as
SDI
for the section of the processor you're working on.
There will only be one program to choose from, as Remap uses UHD video only.
2.
On the Input tab, under
Pixel Format
, choose
Square Division
.
3.
On the
Video
tab, uncheck
Enable Force Video Standard
.
