Imagine communications Selenio 6800+, Installation And Operation Manual

Page: 40 / 54

Chapter 5
Command Parameters
26
Copyright © 2011, Harris Corporation
Output Specifies the contents of the transport stream
output.
„
All - The entire multiplex (MPTS).
„
Program - Only the selected program (SPTS).
Note: When using the CAM card for
decryption, the SRC has the ability to put
out the entire multi-program stream, while
decrypting only a single program.
The Program Number and Output
parameters work together as follows:
„
When Program number is non-zero and
Output is set to Program - the selected
program is decrypted and put out.
„
When Program number is non-zero and
Output is set to All - the selected program is
decrypted and all programs are put out.
„
When Program number is zero and Output
is set to Program , no program is selected and
only the unreferenced PIDs, if any, are put
into the output stream.
„
When Program number is zero and Output
is set to All , all programs are decrypted and
put out.
All, Program All
Output Rate (Mbps) Specifies the output transport stream bitrate
used if output=program, 0 for VBR. 0.000 to 214.000 0
Unreferenced PID[1-4] Specifies up to four different PIDs that are not
referenced in the PMT. 0 to 8190 0
Enable CAM Enabled CAM (Conditional Access) functionality. Enable, Disable Disable
Configuration > Network
Link Specifies the Ethernet interface's link speed. Off
Auto
10BaseT
10BaseT Half
100BaseT
100BaseT Half
Auto
IP Address Specifies the Ethernet interfaces's IP address. IP Address
0.0.0.0
IP Mask Specifies the Ethernet interface's IP mask. IP Address
0.0.0.0
IP Gateway Specifies the Ethernet Interface's IP gateway
address. IP Address
0.0.0.0
Table 5-1 Configuration Parameters
Command Path Description Options Default