Imagine communications Selenio 6800+, Installation And Operation Manual

Page: 36 / 54

Chapter 5
Command Parameters
22
Copyright © 2011, Harris Corporation
Parameters
How To Use Telnet
1 On a Windows PC, click the Start > Run , type cmd and press ‘Return’ to open a DOS
dialog box.
2 Begin a Telnet session by using the system’s IP address and typing the following into the
DOS dialog box.
telnet <system IP Address>
3 The system prompts for a username and password. The following username and password
are factory defaults.
username: admin
password: admin
Once a Telnet connection is established, commands listed in the following sections can be
directly executed.
Parameter Usage Notes
Many of the ‘Command Paths’ in the following sections depict a range of values in square
brackets ‘[ ]’.
Configuration > RF[1-4]
Substitute one value from the range to create a command string.
Configuration > RF1
Configuration > RF2
Add an equals sign ‘=’ and value from the ‘Options’ column to complete the command
string.
Configuration/RF1/Pilot=On