iglu Inuit 6I, Installation Manual

Page: 5 / 73

5
INTRODUCTION
This installation manual provides information on the installation of the IGLU heat pump. It is an integral part of the product
and must be easily accessible to the installer. The manual must be available throughout the life of the device. In the event
of a change in the owners of the device, the manual must be passed on to the new owners or users.
Read the instructions before installing the heat pump. Follow all instructions as specified by the manufacturer.
If you have any questions, please contact the company that performs the installation of heat pumps or your local
manufacturer’s representative.
This installation manual was written for several types of devices; you must always follow the parameters applicable to the
respective type of equipment.
PURPOSE
The manual is intended only for persons who install the devices. Treat all constituents responsibly. The heat pump may
only be used for its intended purpose, which means:
•
heating.
•
domestic hot water preparation.
•
cooling.
The device can only be operated according to its technical parameters.
LIABILITY
The manufacturer shall not be liable for damage caused by improper use or installation of the heat pump. The
manufacturer’s liability shall also not apply:
•
if work has been performed that differs from the specifications in these operating instructions.
•
if work has been carried out on the equipment which is not described in this manual or which has not been approved in
writing by the manufacturer.
•
if the equipment or its components have been modified, altered, or removed without the written consent of the
manufacturer.
WARRANTY

The product has a 24-month warranty upon submission of the purchase documents.

The product warranty can be extended up to 60 months with annual heat pump maintenance.

Warranty and post-warranty provisions are available in the purchase documents.
PRODUCT PACKAGING AND TRANSPORTATION
After purchasing a heat pump:
• Inspect the delivered product for external damage during delivery.
• In the event of delivery defects, submit a claim to the company that sold the device immediately.
The heat pump may only be transported and stored in an upright position. The device can only be temporarily tilted, not
laid down. The device can be stored at a temperature no lower than 10 °C .