iglu Inuit 6I, Installation Manual

Page: 38 / 73

38
SELECTING A LOCATION IN COLD CLIMATES
When operating the unit in a low outdoor ambient temperature, be sure to follow the instructions described below .

To prevent exposure to wind, install the unit with its suction side facing the wall.

Never install the unit at a site where the suction side may be exposed directly to the wind.

To prevent exposure to wind, install a baffle plate on the air discharge side of the unit.

In heavy snowfall areas, it is very important to select an installation site where the snow will not affect the unit. If
lateral snowfall is possible, make sure that the heat exchanger coil is not affected by the snow (If necessary,
construct a lateral canopy).
1. Construct a large canopy.
2. Construct a pedestal. Install the unit high
enough off the ground to prevent it from being
buried under snow.

The outdoor unit should be installed with consideration of the direction of strong winds. These can make the unit
turn over, so the side of the unit should be set to face the wind, not the front of the unit.
ELECTRICAL CONNECTIONS
INDOOR UNIT INSTALLATION