ifm
Basic Device Manual AS-i ControllerE M4 Target V15
2015-10-30
Menu
Main menu [System Setup]
111
Menu tree
Description
System Setup
Ethernet Setup
Baudrate
► Scroll in the possible parameters with [▲] or [▼]
► Save new baud rate with [OK]
>
Display of the message "WAIT" while saving
>
Return to the menu [Baudrate].
System Setup
Ethernet Setup
Auto Negotiation
Automatic negotiation of the baud rate and transmission
(full/half-duplex) between the Ethernet participants:
► Scroll between ON and OFF with [▲] or [▼]
► Adopt with [OK].
>
Display of the message "Wait" while saving
>
Return to the menu [Auto Negotiation]
System Setup
Ethernet Setup
DHCP Setup
Automatic assignment of the IP address by an available DHCP
server:
► Scroll between ON and OFF with [▲] or [▼]
► Adopt with [OK]
>
Display of the message "WAIT" while saving
>
Return to the menu [DHCP Setup]
System Setup
Ethernet Setup
MAC ID
>
Display of the manufacturer identification number of the
Ethernet participant in the network.
System Setup
Modbus Setup
Only functionable if an Ethernet programming interface is
available (option)!
→ supplement to the manual "Ethernet programming
interface" (option)
► Scroll between enabling and disabling the Modbus support
with [▲] or [▼] (password level 1 required)
System Setup
Firmware Update
Update of the firmware (RTS Runtime System Software)
(password level 3 required):
Requirement: PC/laptop with special software connected to
serial interface
System Setup
Firmware Update
Runtime System
Update of the run time system
>
Display: "RTS Firmware:
Connect to PC
– Start now?"
► [OK]
► Start transmission on the PC
>
Transmission active
System Setup
Firmware Update
AS-i Master 1
Update of the AS-i master 1
► [OK]
>
Display: "AS-i 1 Firmware:
Connect to System
– Start now?"
► [OK]
► Start transmission on the PC
>
Transmission active
