IEMCA KID 80-IV Touch, Manual For Use And Maintenance

Page: 73 / 92

6 - USE AND OPERATION KID 80 IV
EN
6 - Pag. 13 / 19
6.10 LATHE SPINDLE LINER CHANGE
We recommend using a spindle liner in order to guide the bar correctly into the lathe.
The inner diameter of the front nose must be one millimetre larger than the outer diameter of
the bar pusher bearings (see "Bar and bar pusher diameter table", chapter 2).
The replacement must be carried out in the area between the lathe and the bar feeder; move
the bar feeder away if it is equipped with a displacing device, otherwise proceed as indicated:
• See section 6.13 "Cycle performing mode in the step-by-step function" until the bar pusher
high position is reached;
• Press the bar feeder emergency stop button [kid_EMERGENZA] to stop bar feeder operation
in safe conditions;
• Remove safety device (A) (if the bar feeder is
provided with a bar feeder-lathe guide).
• Open the upper guard.
• Remove the reduction nose (from bar feeder side)
and replace it.
• Reset the bar feeder to its regular operating
conditions.