IEMCA KID 80-IV Touch, Manual For Use And Maintenance

Page: 72 / 92

EN
6 - USE AND OPERATION KID 80 IV
6 - Pag. 12 / 19
6.9.1 BAR PUSHER REPLACEMENT PROCEDURE
WARNING - CAUTION
Never perform the following procedure when a bar is detected in the bar pusher
collet!
The replacement of the bar pusher, for a working cycle change or maintenance, may be
performed as follows:
- set the bar feeder to manual mode with closed guide channels;
- press to access the "guide channel and bar pusher change" or "bar feeder reset"
function.
- press and hold to start the automatic procedure allowing the bar feeder to move to the
appropriate condition for bar pusher replacement.
- In particular, by pressing , the bar pusher is moved to its completely backwards low
position, allowing it to be disassembled.
INFORMATION
If during the above-mentioned operations the button is released, the
procedure will stop. By pressing the button again, the procedure will start from
where it was paused.
NEW BAR PUSHER INTRODUCTION
WARNING - CAUTION:
Insert the bar pusher correctly into its seat and secure it.
- Close the bar feeder guard, reset the reset button, enter the manual mode and
press . The bar pusher moves forwards until the clamp position is exceeded by at least
200 mm and the upper guide channels are closed.
- Restore the machining cycle of the bar feeder.