IEMCA KID 80-IV Touch, Manual For Use And Maintenance

Page: 65 / 92

6 - USE AND OPERATION KID 80 IV
EN
6 - Pag. 5 / 19
6.3
Keyboard control description
1 Function access, bar loading and new set-up (guide channel and bar pusher replacement)
button.
2 Programme save or recovery management access button.
3 Selects the "Operator Parameters" mode.
4 Selects the "Iemca Parameters" mode.
5 Error reset button: to restart the bar feeder after the stop caused by an error, press the
button and hold it down until the bar feeder is started.
6 Bar feeder stop button (red light): press this button to stop the bar feeder and reset the
"Errors".
7 Selects the semi-automatic mode.
Press to select, press again to deselect.
8 Activates the "step by step" operating cycle: every time the button is pressed, one step is
performed.
9 Selects the manual mode.
10 Selects the automatic mode.
11 It resets the "BAR FEEDER ZERO SETTING" of the carriage.
Press the 0-AXIS button and release it when the carriage starts moving towards the "BAR
FEEDER ZERO SETTING" position.
12 Remnant detection disabling button
Press the button to feed a "new" bar without the detection of bar remnant in the bar pusher
collet.
13 Allows to return to the main menu display.
14 Moves the bar pusher at a low speed
15 Moves the bar pusher at high speed.
16 Displays the software and the push-button panel identification data.
ID Progr.9 AUTOMATIC MODE 0
Open Collet
Total pieces: Machinable pieces: