IEMCA Elite Evo Series, Manual For Use And Maintenance

Page: 137 / 188

6 - USE AND OPERATION Elite112_220_Evo_SIII
EN
6 - Pag. 23 / 23
6.6.5 Cycle performing mode in the STEP BY STEP function
Foreword
This mode may be used for many reasons, as for instance:
• to open the guide channels;
• to check a complete bar change cycle;
• to check the bar feeder mechanics;
• to load a single bar so as to check the facing;
• etc.
Procedure
1 press to start the bar feeder;
• check that the guide channels of the bar feeder
are closed. If not, close the guide channels in
manual mode.
2. press and then to select the
semiautomatic function;
3 press , the bar feeder performs the first
step (bar pusher return);
4 press , the bar feeder performs the second step, and so on.
5 once the maximum opening condition of the upper guide channels is reached, press to
start the bar feeder device.
6 press , the bar feeder carries out the first feeding return, and so on until the new bar is
positioned into the lathe spindle.
Bar feeder in stand-by
AUTO or MANUAL?