IEMCA Elite Evo Series, Manual For Use And Maintenance

Page: 98 / 188

EN
5 - ADJUSTMENT AND SETUP Elite112_220_Evo_SIII
5 - Pag. 6 / 6
WARNING - CAUTION:
barstock diameters for any guide channel are only given as an indication. A
diameter of a bar to be machined approximately 6 mm smaller than the guide
channel diameter may cause vibration and failure to the bar feeder. Therefore, it
may be necessary to slow down the bar rotation speed or to change the guide
channel diameter in order to obtain the best performance for a specific
application.
WARNING - CAUTION:
the collet external diameter should be at least 0.5 mm smaller than the bar
pusher external diameter.
INFORMATION:
the bar feeder is usually supplied with a bar pusher whose diameter is equal to
the lathe spindle drawbar hole. Sometimes, in order to ensure the best working
conditions, it may be necessary to use a bar pusher with a smaller diameter.