IEMCA Elite Evo Series, Manual For Use And Maintenance

Page: 109 / 188

5 - ADJUSTMENT AND SETUP Elite112_220_Evo_SIII
EN
5 - Pag. 17 / 17
Microswitch S92
• Rotate manually shaft (A) until the headstock
starts its return stroke with closed collet.
• Release the "S92" microswitch wheel.
• Continue rotation until the headstock has
completed its return stroke.
• Lift wheel "S92".
Microswitch S99
When the threading tool starts its return stroke,
lower "S99" microswitch wheel and lift it before the
stroke is over.
Should microswitch "S99" be fitted on lathe, timing
is to be performed on lathe cam.
GENERAL REMARKS
• Microswitch activation can be either delayed or
advanced through screw (C).
• Whenever servicing the camshaft of the lathe, disconnect the cam box, according to the
following procedure:
- loosen clamp (D) and unscrew sleeve (E);
- service the lathe camshaft;
- screw sleeve (E) and tighten clamp (D);
- should shaft (F) be out of phase, loosen sleeve (G) screws, rotate it and tighten the
screws.
5.5 BAR SUPPORT ASSEMBLY
The small diameter bar support is disassembled
and placed on the magazine during transport.
During installation it should be fixed to the tank.
• Loosen screws (A)
• Insert the thin bar support (B)
• Tighten the screws (A)