IEMCA Elite Evo Series, Manual For Use And Maintenance, Page: 97 / 188

5 - ADJUSTMENT AND SETUP Elite112_220_Evo_SIII
EN
5 - Pag. 5 / 5
5.3 SETUP ACCORDING TO THE BAR TO BE MACHINED
According to the "new" diameter of the bar to be machined, a few or several operations must be
carried out based on the diameter of the previously machined bar.
The table (regarding the ELITE guide channel, bar pusher, bar and pipe diameter) reports the
diameters of available guides as well as the range of the bar pushers that can be assembled,
and the diameters of the bar to be machined.
ELITE 220 guide channel, bar pusher, bar and pipe diameters.
GUIDE
DIAMETER
(mm)
REVOLVING TIP
DIAMETER(mm)
BAR DIAMETER(mm)
LARGEST TUBE
DIAMETER (mm)
(*)
MIN MAX
ELITE
6 5,5 2 (1,6) 4,7 5,5
8 7,5 2 6,4 7
11 8,5 3 7,4 8
11 10,5 3 8 10
14 12,5 3 10 12
14 13,5 3 11 13
16 15,5 4 13 15
18 16,5 4 14 16
18 17,5 4 15 17
20 18,5 4 16 18
20 19,5 4 17 19
22 20,5 5 18 20
22 21,5 5 19 20
24 22,5 6 19 20
24 23,5 6 20 20
ELITE 112 guide channel, bar pusher, bar and pipe diameters.
GUIDE
DIAMETER
(mm)
REVOLVING TIP
DIAMETER(mm)
BAR DIAMETER(mm)
LARGEST TUBE
DIAMETER(mm) (*)
MIN MAX
ELITE
5 4,5 0,8 3,5 4
6 5,5 1,5 4,7 5
8 7,5 2 6 7
11 10,5 4 8 10
14
12,5 5 10 12
13,5 5 11 13
16 15,5 6 12,7 13
(*) Valid also for prepared bars or normal bars machined with front remnant ejection.