IEI Technology WAFER-8523, User Manual

Page: 37 / 177

WAFER-8523 User Manual
Page 22
3.1 Anti-static Precautions
WARNING!
Failure to take ESD precautions during the installation of the
WAFER-8523 may result in permanent damage to the WAFER-8523
and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the WAFER-8523. Dry climates are especially susceptible to ESD. It is therefore
critical that whenever the WAFER-8523 or any other electrical component is handled, the
following anti-static precautions are strictly adhered to.
Wear an anti-static wristband : Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding : Before handling the board, touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad : When configuring the WAFER-8523, place it on an
antic-static pad. This reduces the possibility of ESD damaging the
WAFER-8523.
Only handle the edges of the PCB : When handling the PCB, hold the PCB
by the edges.
3.2 Unpacking
3.2.1 Unpacking Precautions
When the WAFER-8523 is unpacked, please do the following:
Follow the anti-static precautions outlined in Section 3.1 .
Make sure the packing box is facing upwards so the WAFER-8523 does not
fall out of the box.
Make sure all the components shown in Section 3.3 are present.