MorphoWave
TM
OEM
Annex 1 : Maintenance
2015_2000009096 V6
January 2019
IDEMIA
D
OCUMENT
–
R
EPRODUCTION AND
D
ISCLOSURE
F
ORBIDDEN
91
Maintenance procedures
Pairing procedure between MorphoAccess and PC
The pairing process between MorphoAccess Sigma Wave and PC is automatically
activated for security reason and data protection between both devices. It allows the
MorphoAccess Sigma Wave and the PC to trust each other and share data encrypted
for security reason.
To pair a MorphoWave
TM
OEM we recommend:
-
To follow the installation procedure described in this document and let the
Ethernet switch disconnected from customer network. The goal is to isolate
the MorphoWave
TM
OEM from the customer network at the first boot so as
to avoid any conflicts due to of the IT architecture of customer network.
-
To make sure corresponding ports of the Ethernet switch are connected to
the MorphoAccess Sigma Wave and the PC.
-
To use a fresh MorphoWave
TM
OEM unit directly from factory never paired
together.
-
Then to switch on MorphoAccess Sigma Wave and the PC in the same time
slot (ie 20 seconds tolerance).
o
If the MorphoAccess Sigma Wave and the PC are not powered on at
the same time, it is likely that the MA will restart the PC. The pairing
process may take up to 6 minutes in such case. Please do not touch
the product during this period.
-
During the pairing process, you may see on MorphoAccess Sigma screen:
-
Once the pairing has been performed successfully, following screen will be
displayed:
