2. Installation & wiring
Function
4. Support tool
5. Appendix
1. Overview
3-27
Slave mode
z
Control commands
The WB1F can be controlled by inputting control commands from the host device to the WB1F.
An example of the control command output format is as follows.
Example: To send the "indicator LED (red) on" control command
z
Request (host device
→
WB1F)
Prefix
Mnemonic
Suffix
^
leda1
CR
LF
z
Response (WB1F
→
host device)
Normal response
Prefix
Judgment
Suffix
^
OK-00
CR
LF
Error response
Prefix
Judgment
Suffix
^
NG-ff
CR
LF
z
The error response is when a fault occurs such as a mistake in command input.
z
For the other communication commands, refer to
P. 5-6 "5. 5 Control commands list"
z
The check digit can be added to the control command response.
z
The response time for control commands (excluding save, initial) is within 10 ms. The save command is with-
in 2 s, the initial command is within 10 s.
Summary of Contents for WB1F Series
Page 1: ...B 1775 6 WB1F Fix Linear CCD Scanner User s Manual...
Page 115: ...B 1775 6 September 2019...
Page 116: ...B 1775 6...