IDEC WB1F Series, User Manual

Page: 2 / 116

2. Installation & wiring 3. Functions 4. Support tool 5. Appendix 1. Overview
i
Introduction
Introduction
Attention
z
IDEC Corporation holds all rights related to this manual. Unauthorized duplication, reproduction, sales, transfers, or leas-
ing without the express consent of IDEC is prohibited.
z
The content of this manual may change without prior notification.
z
We have taken all possible measures with the content of this product, but if you notice any portions that are unclear, or
any mistakes, please contact the dealer where purchased or an IDEC sales representative.
Applicable standards
The applicable standards that this product supports are listed below.
z
IEC/EN 60950-1 (2005)
z
IEC/EN 61000-6-1 (2007)
z
IEC 62471 (2006)
z
IEC 61000-6-3 (2006)
z
EN 61000-6-3 (2007)
z
EN 55022 (2010) Class B
z
EN 55024 (2010)
z
UL 60950-1, 2nd Edition, 2011-12-19
z
FCC Part 15 Subpart B Class B (Verification)
z
CSA C22.2 No.60950-1
z
ICES-003 Class B (self-declared)
z
VCCI Class B (compliance confirmed)
FCC Regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures;
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Canadian Department of Communications Compliance Statement
• CAN ICES-3(B) / NMB-3(B)
For details on the applicable standards, please inquire with the distributor where purchased.