Innovative Circuit Technology Ltd.
33
Click the
All Outputs ON
or
All Outputs OFF
button to enable or disable all
four output channels simultaneously. All outputs are enabled as the factory
default setting. Any output channel that has the power cycling option
enabled will go through the cycle when the
All Outputs OFF
button is clicked.
Module Setup
Power-On Sequencing / Power Cycling
Delay Time:
Enter a delay time to be used for the wait time before enabling
an output channel that has the power cycling enabled.
Alarm Reporting
Activate Alarm Form C Contact:
Check this box (default) to have the back
panel alarm contacts change state for an alarm condition.
Send E-mail:
Check this box to have an alarm e-mail sent to the e-mail
address(es) set up in the
Communications E-MAIL SETUP
page.
Module Output Configuration
Select an Output to edit
Select output
#1
to
#4
to be edited in the
Select an Output to edit
box.
Output #_ Settings
Output Label
: Enter a descriptive label for a selected output channel if
desired.
Output State after Power Loss
: Sets the state for an output channel after
the LDM loses all input power, then recovers. Select one of the following:
•
Restore last State
: This will return the output contactor to the
state prior to the reset event (default).
•
Enable Output
: This will enable the output contactor,
regardless of its previous state.
•
Disable Output
: This will disable the output contactor,
regardless of its previous state.
Ignore Circuit Breaker Status:
Check this box to mask the circuit breaker
open circuit detection to prevent false alarms on an unused output channel.
Enable Power Cycling:
Check this box to enable output power cycling for a
selected output channel. Power cycling is activated whenever the output is
disabled using the
Module Output Control Off
button or
Master Output
Control All Outputs OFF
button in the
Module Control
section, or when the
Network Watchdog
is triggered. The output will automatically be re-enabled
after the
Power Cycling Delay Time
in the
Module Setup
has finished. The
Power
Cycling Delay
Time
must be set with duration long enough for the
connected network hardware to fully reset for this function to be effective.