ICS Nav6plus, User Manual

Page: 25 / 90

NAV6 plus NAVTEX System User Guide
25
Stations
The picture shows the 518 Stations filter
page; the 490 Stations filter page is
similar. Use the UP and DOWN keys to
select the station filter setting that you wish
to edit. Use the LEFT and RIGHT keys to
change the setting.
The ‘Auto Station Filter’ setting can be
either Nearest or In Range. This setting is
active only when you have a GPS receiver
connected to the NMEA input and it
applies only to stations set to Auto. To
display messages from the nearest station
to your current position, set the auto
station filter to Nearest.
To display messages from all stations in
range of your current position, set the auto
station filter to In Range.
An asterisk appears next to all stations for
which messages will be displayed.
Set the filter for each station to one of the following:
Setting Notes
On Messages from station always displayed
Off Messages from station never displayed
Auto Messages from station displayed only when nearest or in range
depending upon ‘Auto Station Filter’ setting.
Important: You may wish to leave your NAV6 plus running whilst your
GPS or instrument system is switched off. Be aware that the Navigate
data items derived from NMEA (including position) will time out after a
short while. If you have chosen to display only the ‘nearest’ NAVTEX
station or stations ‘in range’ it will revert to displaying all stations that are
set to ‘Auto’. As soon as the NMEA data becomes available again only
the ‘Nearest’ or ‘In Range’ stations will be displayed dependant upon
your current settings.