2-11
2
2.8
N4865A RACK MOUNTING INSTRUCTIONS
The Model N4865A is held in its rack mounting kit with a winged-’U’ shaped
bracket. Perform the following steps to install a N4865A in a rack mounting
kit:
1. Hold the N4865A at a 30 degree nose down angle and place the front
bezel through the rack mount kit from the rear of the kit. Push it forward
through the opening until the rubber feet line up with the holes in the rack
mounting kit. Push the unit down until it rests fl at on the kit and the feet
are in the four holes.
2. Repeat step 1 for a second unit if two units are being held in one rack
mounting kit.
3. Align the unit(s) so the bezels are parallel with the front of the rack
mount kit and protrude equally through the front
panel of the rack
mounting kit.
4. Set the bracket so its two holes line up with the holes in the rack mount-
ing kit extrusion. Use the supplied 4-40 screws to hold the bracket to the
extrusion. Do not overtighten.
5. Use the supplied 10-32 screws to bolt the rack mounting kit into the
rack.
Summary of Contents for N4865A
