ICS N4865A, Instruction Manual

Page: 27 / 100

2-7
2
later on. Also set the Net Mask and Gateway values. Check the entered
values carefully as the unit’s webserver does minimal error checking.
Press the ‘Update Flash’ button when done. A Confi rmation Page similar
to the one shown in Figure 2-6 will appear in your browser.
Figure 2-6 N4865A Confi rmation Page
8. The Confi rmation Page affi rms that the new settings have been saved in
the unit’s fl ash memory. Press the ‘Reboot’ button to reboot the unit and
activate the new settings. A Rebooting Page similar to the confi rmation
page will appear in your browser.
9. Relink to the N4865A and verify that all of your settings are correct. You
may have to change the PC’s Local Area Network settings if you selected
a Static IP outside of the AutoIP range of 169.254.xxx.xxx.
10. Connect the PC back to the company network if it had been disconnected
and restore its Local Area Network settings to the original values recorded
in Step 3.
2.5.2 RPC Confi guration Method
The RPC Confi guration method involves using selected RPC commands from
those listed in Appendix 3 to change the N4865A settings. Refer to Appendix
2 and ICS’s Application Notes for more information about using RPC com-
mands.