ECAT-2011H EtherCAT Slave I/O module
Copyright © 2018 ICP DAS CO., Ltd. All Rights Reserved.
-
20 -
3.3
Self-Test
This chapter can give you the detail steps about self-test. In this way, user can confirm that
ECAT-2011H well or not. Before the self-test, you must prepare a stable signal source (e.g., dry
battery) is available, and than follow the steps described below:
Wire the
stable signal source (e.g., dry battery) to AI channel 0
.
Connect the
V0- (Pin01)
to
signal positive(-)
.
Connect the
V0+ (Pin02)
to
signal po)
.
In the left-hand window, click
“AI0”
to get and configure state.
In the right-hand window, check the voltage vaule in the
“Value”
item.
Figure 3-3.1
(+)
(-)
Dry Battery
Figure 3-3.2
