ICON BIA-iPROTECT, Installation And Operation Manual

Page: 2 / 20

2
iCON iProtect Instruction Manual Rev 4.4
1 . Introduction
Thank you for choosing a Bianco iCon iPROTECT Intelligent Pump Controller.
An iPROTECT provides significant protection for direct start (DOL), single phase pumps from
0.37kW – 2.2kW with PSC MOTORS (Permanent-Split Capacitor) with start and run
windings). It also offers a number of control and operation modes to suit a variety of
applications.
The controller is easy to set up with a push button calibration for over and under-load.
The iPROTECT also allows for dry-run protection without float switches or probes.
The LCD screen displays the pump running state and provides the user a wealth of useful
information.
The iPROTECT is particularly useful where there is the need to control and protect single
pump installations managing the automatic operation by a variety of switching methods.
2 . Contents
1. Introduction ............................................................................................... 2
2. Contents .................................................................................................... 2
3. Technical Specifications ............................................................................ 3
4. Warnings and Cautions .............................................................................. 3
5. Display ....................................................................................................... 4
6. Operation and Programming - navigation .................................................. 5
7. Program Parameters .................................................................................. 6
8. Programming for Cutter/Grinder/Macerating pumps ................................. 8
9. Drainage Mode - Electrical Connections; floats or probes ........................ 9
10. Drainage Mode – Control via Pump Float ................................................. 10
11. Drainage Mode – LCD running state images ............................................ 10
12. Transfer Mode - Electrical Connections; floats or probes ....................... 11
13. Transfer Mode - LCD running state images ............................................. 12
14. Boosting Mode - Electrical Connections; floats or probes ....................... 13
15. Boosting Mode - LCD running state images ............................................. 14
16. Bore Pumps - Connecting 2 wire and 3 wire bore pumps ........................ 15
17. Communication link – RS485 ................................................................... 16
18. Fault messages – possible causes and solutions ..................................... 18
19. Warranties – Terms and Conditions ......................................................... 19