8
iCON iProtect Instruction Manual Rev 4.4
Delay time for starting the pump in seconds
In auto mode, when the controller has met the conditions to start the
pump, there will be a delay equal to setting 016 parameter
Default setting is 0 seconds
Delay time for stopping the pump in seconds
In auto mode, when the controller has met the conditions to start the
pump, there will be a delay equal to setting 016 parameter
Default setting is 0 seconds
If a replacement pump is installed, the previous calibration should be removed
and a new calibration performed.
Consult White International prior to changes to parameters 001 to 017.
Changes without consulting White International may void your pump warranty.
8. Programming for Cutter/Grinder/Macerating pumps
Pumps fitted with a cutting, grinding or macerating mechanism are at risk of jamming or
attempting to start in a ‘locked rotor’ state.
The iProtect, due to its rapid response, the provides superior pump protection compared
to traditional overload setups.
For pumps with a cutting, grinding or macerating mechanism, the installer may elect to
manually enter the pump nameplate kW at Parameter 008 to ensure the pump can
achieve its maximum torque.
Note: if the running power is less than 75% of the rated full load power check the pump sizing or system.
For pumps controlled by their own float, see Section 9.
Program parameter 009 to 0%
