49
o
This code stays displayed and flashes every 5 seconds.
o
The unit begins to measure after 15 seconds and displays the speed of the approaching
vehicles, according to the chosen parameters.
•
C = ERASE UNIT MEMORY
o
Choose "C"
o
The erasing process starts after 10 sec.
•
P = UPLOAD PARAM "TAILOR MADE" ZONE TO THE UNIT
The unit must be powered and in measurement mode.
o
Press the settings encoder button for 3 seconds.
o
When the settings encoder display stops blinking, release the button.
o
The encoder display blinks quickly.
o
Then press the button to scroll through the menus (they scroll in a loop).
o
When the "P" menu appears on the encoder, wait 3 seconds, until the encoder display
shows "u".
o
Insert the USB stick into the USB port.
o
The I-SAFE reads the data from the USB stick and the dot next to the "u" flashes.
o
Do not remove the stick while the dot
next to the “u” is flashing.
o
When the display shows P again, the USB stick can be unplugged.
o
Press the button again for 3 seconds and release when the display stops flashing.
o
Scroll through menus again until the encoder
displays “
-
”
.
o
"-" stays displayed and flashes every 5 seconds.
o
The unit begins to measure after 20 seconds and displays the speed of the approaching
vehicles, according to the chosen parameters.
•
B = Bluetooth module configuration
•
Ͱ
= TEST (LED segments, battery level, etc.)
•
A = DEMO/VALIDATION (based on the last selected zone parameters - display by steps of 10 km/h,
looped sequence)
If no ZONE is chosen, the display automatically switches to TAILOR MADE ZONE 1 after four minutes.
