20
If you choose to set up the device using a USB stick, select next which type of device you want to set:
Screenshot 2: assistant, step 2
–
Product setup choices using a USB key
See further in this document, p. 21 and following, for texts, pictograms and speed thresholds settings.
You can create up to 3 custom zones.
Once the parameter file(s) saved on your USB key and ready to be uploaded on the I-SAFE, follow these
steps:
•
The unit must be powered and in measurement mode.
•
Press the settings encoder button for 3 seconds.
•
When the settings encoder display stops blinking, release the button.
•
The encoder display blinks quickly.
•
Then press the button to scroll through the menus (they scroll in a loop).
•
When the "P" menu appears on the encoder, wait 3 seconds, until the encoder display shows
"u".
•
Insert the USB stick into the USB port.
•
The I-SAFE reads the data from the USB stick and the dot next to the "u" flashes.
•
Do not remove the stick
while the dot next to the “u” is flashing
.
•
When the display shows P again, the USB stick can be unplugged.
•
Press the button again for 3 seconds and release when the display stops flashing.
•
Scroll through menus again until the encoder displays
“
-
”
.
o
For custom zone 2: =
o
For custom zone 3
: ≡
•
"-" stays displayed and flashes every 5 seconds.
•
The unit begins to measure after 20 seconds and displays the speed of the approaching
vehicles, according to the chosen parameters.
To maintain the watertight integrity of the unit, ensure that you close the service box door and the
battery slot with the delivered tools.
