8
OPTIONS
8-2
NEVER
immerse the connector in water. If the
connector becomes wet, be sure to dry it BEFORE
attaching it to the transceiver.
HM-184
speaker
microphone
CAUTION:
Firmly attach
to the multi connector, but
do not overtighten.
A loose connection will al-
low water intrusion into
the connector; an over-
tightened connection will
damage the connector
pins in the transceiver.
Coin
Screw
Turn OFF the trans-
ceiver power when at-
taching or detaching
the microphone.
Speaker
Belt clip
Microphone
PTT SWITCH
Hold down to
transmit;
release to receive.
D
To attach
Attach the connector of the speaker microphone into
the multi connector on the transceiver and tighten the
screw.
NOTE:
The microphone element is located at the
top of the speaker microphone, as shown in the
diagram above. To maximize the readability of your
transmitted signal (voice), hold the microphone
Approximately 5 to 10 cm (2 to 4 inches) from your
mouth, and speak at a normal voice level.
TIP:
KEEP
the connector cover attached to the
transceiver when the speaker microphone is not
used. (p. 1-5)
Water will not get into the transceiver, even if the
cover is not attached. However, the terminals (pins)
will become rusty, or the transceiver will function
abnormally if the connector becomes wet.
Previous view
