1
PANEL DESCRIPTION
1-5
Touch panel (Continued)
(This screen is only an example.)
!8
PRIORITY INDICATOR (p. 9-2)
Is displayed during a Priority scan.
L
Blinks while the squelch is forced to open during a
Priority scan. (p. 9-3)
!9
TUNING STEP INDICATOR
(p. 3-2)
Displays the currently selected tuning step.
L
If the tuning step is set by the programmable tuning
step, "◄" is displayed by the indicator.
@0
FUNCTION SCREEN
Displays the operating parameters, modes,
frequencies and indicators, depending on your
selections.
@11
FUNCTION GUIDES
Displays the currently accessible function.
@2
RECEIVED SIGNAL STRENGTH INDICATOR (p. 3-4)
Displays the absolute received signal strength in
terminated or open load measurement.
@3
SIGNAL METER (p. 3-5)
Indicates the signal strength in S-meter/dBµ/
dBµ(EMF)/dBm.
@4
RF GAIN (RFG) (p. 3-1)
Is displayed when the RF gain is set to less than
100% to indicate that the RF gain is reduced.
@5
TUNING INDICATOR (p. 3-4)
Displays the detuned level in the FM, WFM, FSK
and DIGITAL modes.
@6
OVERFLOW (OVF) INDICATOR (pp. 3-1, 5-1)
Is displayed when an excessively strong signal
is received. (Normally, "S" is displayed to in the
S-Meter mode)
@7
AGC INDICATOR (pp. 1-7, 5-1)
Displays the selected AGC time constant setting.
(AGC-F: Fast, AGC-M: Mid, AGC-S: Slow or AGC-OFF: OFF).
@8
ANTENNA INDICATOR (p. 3-3, 5-1)
Displays the selected antenna (ANT1, ANT2 or ANT3) only
when the frequency is set to 10 kHz ~ 29.999999 MHz.
@9
NOTCH INDICATOR (AN/MN) (pp. 1-7, 5-2)
Is displayed while the Notch function is ON. (AN:
Auto Notch or MN: Manual Notch)
#0
NOISE BLANKER INDICATOR (NB) (pp. 1-7, 5-4)
Is displayed while the Noise Blanker function is ON.
#1
NOISE REDUCTION INDICATOR (NR) (p. 1-7, 5-4)
Is displayed while the Noise Reduction function is ON.
#2
TWIN PEAK FILTER INDICATOR (TPF) (p. 5-7)
Is displayed while the Twin Peak Filter function is ON.
#3
DUP INDICATOR (DUP–/DUP+) (pp. 1-7, 5-4)
Is displayed while in the Duplex mode.
#4
TS INDICATOR ("▼") (p. 3-2)
Is displayed when the TS function is on. The
frequency changes according to the tuning step set
in TUNING STEP INDICATOR (
!9
).
L
Touch kHz digit to turn OFF the TS function.
#5
MONITOR INDICATOR (MONI) (p. 3-1)
Appears while the Monitor function is ON.
@9
#0
#1
#2
#3
#5
@8
@7
@5
!8
!9
@6
@0
@1
@4
@2
@3
#4
